Basic Commands (Direct Access); Arm; Disarm - Viper 5806V Owner's Manual

Basic Commands (Direct Access)

Arm

Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
parking lights flash once. The remote control Arm LED and beeps play
to confirm. If Valet Mode* is ON, the doors lock and the Arm LED and
a fault tone plays. Exit Valet Mode to arm the alarm normally.
If a Trigger Zone Fault is detected the siren chirps once again and the
remote will emit a Trigger Zone Fault Report**, the Arm LED and a
fault tone plays.
To Arm and Panic
Press and hold
The alarm arms (or locks in Valet) and, after two seconds, sounds
the siren and flashes the parking lights. The remote control's con-
firmation LED's flash and siren tones play to confirm. Press the
or button to stop the output.
AUX

Disarm

Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The remote control Disarm LED and
beeps play to confirm. If Valet Mode* is ON, the doors unlock and
the Disarm LED and fault tones play.
An Alarm Report** will replace the disarm output if the alarm was
triggered; the siren will chirp four or five times, and the Disarm LED
10
AUX
AUX
AUX
AUX
AUX
AUX
AUX
© 2016 Directed. All rights reserved.
AUX