Optical Drive Blank - HP HPE ProLiant DL120 Gen9 Maintenance And Service Manual

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To remove the component:
Power down the server (on page 30).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 33).
o
Remove the access panel
4.
If installed, remove any expansion board that blocks access to the SSD module
5.
on page 61).
Remove the SSD module.
6.
To replace the component, reverse the removal procedure.

Optical drive blank

To remove the component:
If installed, remove the security bezel
1.
Power down the server (on page 30).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 33).
o
("Access panel" on page 40).
("Remove the security bezel
("Expansion
(optional)" on page 29).
Removal and replacement procedures 47
board"