Exterior Lamps Off; Reminder; Headlamp High/Low-Beam; Flash-To-Pass - Cadillac ATS 2015 Owner's Manual

Cadillac ATS Owner Manual (GMNA-Localizing-MidEast-8087807) - 2015 -
crc - 6/2/14
The high beams may not turn off
automatically if the system cannot
detect other vehicle's lamps
because of any of the following:
The other vehicle's lamp(s) are
missing, damaged, obstructed
from view, or otherwise
undetected.
The other vehicle's lamp(s) are
covered with dirt, snow, and/or
road spray.
The other vehicle's lamp(s)
cannot be detected due to dense
exhaust, smoke, fog, snow, road
spray, mist, or other airborne
obstructions.
Your vehicle's windshield is dirty,
cracked, or obstructed by
something that blocks the view
of the light sensor.
Your vehicle's windshield is
covered with ice, dirt, haze,
or other obstructions.
Your vehicle is loaded such that
the front end points upward,
causing the light sensor to aim
high and not detect headlamps
and taillamps.
You are driving on winding or
hilly roads.
You may need to manually disable
or cancel the high-beam headlamps
by turning the low-beam headlamps
on, if any of the above conditions
exist.

Exterior Lamps Off

Reminder

A warning chime will sound if the
exterior lamp control is left on in
either the headlamp or parking lamp
position and the driver door is
opened with the ignition off.
Headlamp High/
Low-Beam Changer

(Headlamp High/Low-Beam

Changer): Push the turn signal
lever away from you and release, to
Black plate (3,1)
Lighting
turn the high beams on. To return to
low beams, push the lever again or
pull it toward you and release.
This indicator light turns on in the
instrument cluster when the
high-beam headlamps are on.

Flash-to-Pass

This feature allows the high-beam
headlamps to be used to signal the
driver in front of you that you want
to pass.
Pull and hold the turn signal lever
toward you to use this feature.
When this is done the following will
occur:
If the headlamps are off or in
low-beam mode, the high-beam
headlamps will turn on. They will
6-3