Care And Cleaning - Jenn-Air CCG2423 Cooktop Manual

Care and Cleaning
Be sore all controls are OFF and all cooktop parts are cool before cleaning•
Cleaning Chart
Parts Cleaning Procedure
Control Knobs • Remove knobs in the OFF position by pulling each knob straight up.
• Wash in dishwasher or in warm. soapy water. Do not soak or use abrasive cleaners such
as steel wool pads• Rinse and dry.
• Replace knobs, matching the flat part of the knob opening with the flat part of the shaft.
Make sure knobs are in the OFF position.
NOTE: When knobs are removed for cleaning, be careful not to spill liquids through the holes in
the control area.
• • • 4 • o • • • • • • • • • • • • , • • • • • • • • • b , • • • • • • • • • • • • • • • • • • • • • * • • • • , • • • • • • •
Glass Cooktop • Wipe with a clean, damp sponge or cloth. Rinse and dry thoroughly to prevent a filmy residue.
A glass cleaner may be used to remove smudge marks and stains.
Ignitors • Clean with a toothbrush and warm soapy water. Rinse and dry thoroughly.
DO NOT STRIKE or PRY the ignitor. (Refer to illustration of surface burner head.)
Porcelain • Never wipe a warm or hot porcelain enamel surface with a damp cloth. For general
Burner Pan cleaning, wipe with soapy cloth, rinse and dry. To remove grease, spray with
cleaners such as Fantastik or 409*. DO NOT use abrasive cleaning agents. They may
damage the surface.
Surface • Wash them with warm. soapy water and a nonabrasive, plastic,
Burner Grates scrubbing pad or in the dishwasher. For stubborn soils, clean
with a soap-filled, nonabrasive, plastic pad or Cooktop Cleaning
Creme* tPart # 2000000 l/and a sponge.
• The grates are made of porcelain on cast iron and are very
durable, however, they will gradually lose their shine and/or
discolor. This is due to exposure to high temperatures from the
gas flame.
• When replacing the grates, carefully align the tab on the grate with the indentation in the
porcelain burner base. If the grates are not properly aligned, they may rock.
Surface • The surface burner heads are removable. The cap
.UR.tR._AP
Burner Heads portion of the head is porcelain and the port area ca _poas
is aluminum. Wash the burner heads in the sink PPoa, n_P°r_s
with mild detergent and a plastic scrubber.
Indentation
• Check to be sure all ports are open, To open w_t_ P_.,
clogged ports, insert a straight pin directly into each
port. Do not enlarge or distort the port. _a__n_o,
• When replacing the burner heads, carefully align the
tab on the burner base with the indentation in the
_" ]/'_ _ _'_/_]"_Tab
head. The two pins will fit in the slots when the tab
is aligned with the indentation.
BURLIER BASE
NOTE: When burner heads are removed for cleaning, do not spill liquids through the holes in the
burner base.
• Brand
names
are trademarks of the respective
manufacturers.