PIAGGIO Beverly Tourer 250 i.e. Service Station Manual page 161

Beverly Tourer 250 i.e.
Injection
d. Connectors
B: Chassis earthing
C: Fuel supply
a. Broken fuel pump
b. Dirty fuel filter
D: Ignition system
a. Faulty spark plug
b. Broken coil
c. Broken shielded cap
E: Intake circuit
a. Dirty air filter
b. Dirty by-pass circuit
c. Faulty Stepper motor
F: Other
a. Incorrect distribution timing
b. Wrong idle mixture
c.Incorrect reset of the throttle valve position sensor
2 MIU system faults may be caused by loose connectors. Make sure that all connections have been
correctly made.
Check the connections as follows:
A check that the terminals are not bent.
B check that the connectors have been properly connected.
C check whether the malfunction can be fixed by shaking the connector slightly.
3 Check the entire system before replacing the MIUIf the fault is fixed by replacing the MIU control unit,
install the original control unit again and check if the fault occurs again.
4 When troubleshooting use a multimeter with an internal resistance over 10 Ohm /V. Instruments that
are not suitable might damage the MIU control unit. Instruments must be used with definitions over 0.1V
and 0.5 W , the precision must be greater than 2%.
1. Before fixing any part of the injection system, check to see if there are any registered faults. Do not
disconnect the battery before checking for faults.
2. The fuel feed system is pressurised at 250 kPa (2.5 BAR). Before disconnecting the quick coupler
of a pipe in the fuel supply system, check that there are no naked flames, and do not smoke. Act with
caution to prevent spraying in the eyes.
3. When fixing electric components, operate with the battery connected only when actually required.
4. When functional checks are performed, check that the battery voltage is over 12V.
5. Before trying to start up, check to make sure there is at least two litres of fuel in the tank. Failure to
respect this norm will damage the fuel pump.
INJEC - 161