Stretch Hose And Hose Anchor; How To Transport Cleaner; Dirt Container & Perma Filterb With Cleanstreamtm Filtration Removal And Replacement - Dirt Devil M089800 Owner's Manual

*STRETCH HOSE AND HOSE ANCHOR:
The Hose Anchor is used to prevent the vacuum from tipping while using the above
floor cleaning attachments. Remove the stretch hose from side of the cleaner using the handle. Lay hose over the back of cleaner (Diagram
1) and secure hose anchor ring (Diagram 2a). located around hose to base. Pull hose from hose handle for additional length (Diagram 2b)-
TELESCOPlC WAND:
Remove wand from side of cleaner by pulling out at the top to unsnap and pull up (Diagram
3 ) .
Twist
and pull wand apart for extra length, as described on wand. Twist again to lock.
CARPET SETTINGS
Move lever to adjust height of nozzle to match the surface being cleaned (Diagram 4). If cleaner is difficult to push, adjust to a higher
carpet setting.
HOW TO TRANSPORT CLEANER
Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 5).
NOTE: Do not push or pull cleaner forward while in the upriaht position leaning on back casters.
CLEANING DlRT CONTAINER & PERMA FILTER" WITH CLEANSTREAMTM FILTRATION:
For addi-
tional filtration, a removable filter is located inside the dirt container. The filter does not need to be replaced but should be cleaned reg-
ularly for maximum performance.
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG BEFORE SERVICING.
Empty & Clean DIRT CONTAINER:
1. Depress latch to remove dirt container from cleaner (Diagram 1). Pull dirt container out to empty (Diagram 2).
2. Remove and clean the PERMA FILTERmwith Cleanstream" Filtration (see instructions below).
3. Use a sponge and lukewarm water to wipe dirt container compartment clean.
4. Replace Dirt Container: Set aligning tab on bottom of dirt container into rectangular slot on the cleaner, and push to snap into place
(Diagram
3).
If dirt container does not snap into place, check to make sure the filter is secured properly.
CLEAN THE PERMA FILTER" WITH CleanStreamm FILTRATION (internal) located in dirt container:
1. Remove dirt container. Hold dirt container, grasp inside ring at top of filter and firmly pull the filter up and out (Pg. 8
-
Diagram 4).
2. Regular Maintenance*: Each time the dirt container is emptied, the filter should be cleaned. Gently tap the filter firmly against the
inside of a trash can until dirt stops falling from the filter. (Filter will be discolored after use, this will not affect the filter's performance.) Do
not brush the filter.
3.
Deep Cleaning*: If the Performance Indicator Wheel on the front of the handle is spinning you should notice a decrease in the vacuum's
power or suction. If this happens, inspect the cleaner for clogs, empty the dirt cup and remove all dust and debris from the filter. Once
cleaned the vacuum will immediately be ready for use.
4. Replace the PERMA FILTERmwith CleanStreamT" Filtration: Align angle of filter with angle of dirt container (gasket facing up). Push
down on filter to snap into place and prevent dirt leakage. Return dirt cup to cleaner.
* The cleaning instructions may vary depending on the dirt conditions. In some cases, more or less cleaning of the PERMA FILTER@with
CleanStreamTM Filtration may be required.