Do Not Disturb Mode; Nuisance Call Block - Panasonic KX-TGJ322E Operating Instructions Manual

Do not disturb mode

Do not disturb mode allows you to select a
period of time during which the handset will
not ring for outside calls. This feature is useful
for time periods when you do not want to be
disturbed, for example, while sleeping. Do not
disturb mode can be set for each handset.
Using the phonebook's category feature
(page 20), you can also select categories of
callers whose calls override do not disturb
mode and ring the handset (Caller ID
subscribers only).
Important:
R Make sure the unit's date and time setting
is correct (page 15).
R We recommend turning the base unit ringer
off (page 26) in addition to turning do not
disturb mode on.
R If you have set the alarm, the alarm sounds
even if do not disturb mode is turned on.
Turning do not disturb mode on/off
1
MMENUN (right soft key) #238
2
MbN: Select the desired setting. a MOKN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature. a MOKN
4
Enter the desired hour and minute you
wish to end this feature. a MOKN a
MOFFN
Changing the start and end time
1
MMENUN (right soft key) #237
2
Continue from step 3, "Turning do not
disturb mode on/off", page 31.
Setting the ring delay
This setting allows the handset to ring during
do not disturb mode if the caller waits long
enough. After the selected amount of time
passes, the handset rings. If you select "No
Ringing", the handset never rings during do
not disturb mode.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
TGJ32xE(en)_0305_ver011.pdf
1
2
Note:
R When the answering system answers the
Selecting categories to bypass do
not disturb mode
1
2
3

Nuisance call block

This feature blocks calls from unwanted
callers (Caller ID subscribers only). The
following items are available when storing
phone numbers in the call block list (100 max.).
– "Single Number": The unit blocks calls
– "Range of Numbers": The unit blocks
You can also set the unit to block calls that
have no phone number.
When a call is received, the unit does not ring
while the caller is being identified. If the
caller's phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
Important:
R Blocked calls are logged in the caller list.
31
Programming
MMENUN (right soft key) #239
MbN: Select the desired setting. a MOKN
a MOFFN
call, this feature does not work.
MMENUN (right soft key) #241
MbN: Select the desired categories. a
MSELECTN
R " " is displayed next to the selected
category numbers.
R To cancel the selected category:
MbN: Select the category. a Press
MSELECTN again. " " disappears.
MOKN a MOFFN
from specific phone numbers.
calls that begin with a number stored in the
call block list, such as a toll-free phone
number prefix or certain area codes.
31
2015/03/05 14:31:40