Toro 04384 Service Manual page 93

Disassembly (Fig. 37)
1. Park machine on a level surface, engage parking
brake, lower cutting units and stop engine. Remove key
from the ignition switch.
2. If necessary, remove muffler to allow disassembly of
traction neutral assembly (Fig. 39). Refer to Exhaust
System in the Service and Repairs section of Chapter 3
-- Diesel Engine for additional information on muffler re-
moval.
CAUTION
The extension spring (item 17) is under tension
and may cause personal injury during removal.
Use caution when removing the spring from the
pump neutral assembly.
3. Remove components from traction neutral assembly
as needed using Figure 37 as a guide.
Assembly (Fig. 37)
1. Install removed components to traction neutral as-
sembly using Figure 37 as a guide along with the follow-
ing:
CAUTION
The extension spring (item 17) is under tension
and may cause personal injury during installa-
tion. Use caution when installing the spring to
the pump neutral assembly.
A. If pivot plate (item 32) was removed from pump
trunnion shaft, make sure that both trunnion shaft
and plate bore are thoroughly cleaned before instal-
ling plate to shaft.
B. If damper lever (item 4) was removed, apply anti-
seize lubricant to bore of muffler mount (item 9) dur-
ing assembly.
C. Make sure that ball bearing (item 16) on neutral
arm (item 11) is properly positioned in pump lever
(item 6) after assembly.
2. Install muffler if it was removed (Fig. 39). Refer to Ex-
haust System in the Service and Repairs section of
Chapter 3 -- Diesel Engine for additional information on
muffler installation.
3. After traction neutral assembly has been installed,
make sure that the transmission is adjusted for the neu-
tral position so that the machine does not move or creep
when the traction pedal is in neutral.
Greensmaster 3250--D
6
1. Extension spring
2. Neutral arm
3. Cap screw/flat washer
2
3
4
2
5
1. Muffler
2. Flat washer (6 used)
3. Lock nut (4 used)
Page 4 - - 61
4
2
5
Figure 38
4. Pup lever
5. Piston pump
6. Upper muffler mount
1
2
Figure 39
4. Muffler bracket
5. Cap screw (2 used)
Hydraulic System
3
1
3