General Precautions; When Installing Or Moving - Toshiba e-Studio 281c Operator's Manual

General Precautions

When installing or moving

Warning
• This Multifunctional Digital Colour Systems requires 220 to 240 V AC, 8 A 50/60 Hz electric power. For
Saudi Arabia 100 V version, it requires 127 V AC, 12 A 50/60 Hz electric power.
Do not use a power supply with a voltage other than that specified.
Avoid multiple connections in the same outlet. This could cause a fire or give you an electric shock. If
you are considering increasing the number of outlets, contact an electrician.
• Always connect this Multifunctional Digital Colour Systems to an outlet with a ground connection to
avoid the danger of fire or electric shock in case of short-circuiting. Contact your service representative
for the details. Be sure to use a 3-conductor, grounded wall outlet.
In areas, where a 2-pin plug is used, the Multifunctional Digital Colour Systems must be grounded for
safety. Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
• Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up and cause a
fire or give you an electric shock.
• Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
- Twisting it
- Bending it
- Pulling it
- Placing anything on it
- Making it hot
- Situating it near radiators or other heat sources
This could cause a fire or give you an electric shock. If the power cord is damaged, contact your ser-
vice representative.
• When removing the plug from the outlet, do not pull the power cord. Always hold the plug when remov-
ing it from the outlet. If the power cord is pulled, the wires may become broken and this could cause a
fire or give you an electric shock.
• Make sure that the ventilation holes are not blocked up.
If the temperature within the Multifunctional Digital Colour Systems becomes too high, a fire could
result.
• Do not move the Multifunctional Digital Colour Systems to another building, up and down the stairs or
for any great distance.
This could cause an injury or give you and electric shock. When lifting or moving the Multifunctional
Digital Colour Systems, contact your service representative.
• Do not move the Multifunctional Digital Colour Systems with optional equipment, such as the finisher,
attached.
This could cause a fire or give you an electric shock. When lifting or moving the Multifunctional Digital
Colour Systems, contact your service representative.
• When moving the Multifunctional Digital Colour Systems, be sure to shut down the power prior to pull-
ing out the plug from the outlet. If the power cord is damaged, this could cause a fire or give you an
electric shock.
• The socket outlet should be near the equipment and be easily accessible.
• Pull out the plug from the outlet more than once a year to clean around the prongs. Accumulating dust
and dirt could cause a fire due to the heat released by electric leakage.
11