How To Fill - Sharper Image EVSI-UH201BK Instruction Manual And Warranty Information

How to Fill

CAUTION: Before filling unit with water, turn power off and unplug unit from the outlet.
Note: Always use two hands to carry the water tank.
1. Grasp tank handles with both hands and lift
Fig. 3
2. Turn the tank upside down and remove the
Fig. 4
3. fill the water tank with clean, cool tap water.
Fig. 5
4. Replace the tank cap by turning clockwise
Fig. 6
5. Install both tanks back on the base of the unit.
Note: This unit uses water from one tank at a
time. It will use all the water from one tank before
beginning to pull water from the other tank.
Fig. 7
up from humidifier base. Remove only one
tank at a time (fig. 3).
tank cap by turning it counter-clockwise
(fig. 4).
We recommend using distilled water if you
live in a hard water area (fig. 5).
until tight (fig. 6).
Make sure the tanks are firmly seated (fig. 7).
10
About White Dust
Use of high mineral content hard water may cause a white mineral residue to
accumulate on surfaces in the room near the humidifier. The mineral residue is
commonly called "white dust." The higher the mineral content (or, the harder your
water is), the greater the potential for white dust. The white dust is not caused by
a defect in the humidifier. It is caused only by minerals suspended in the water.
Demineralization Cartridge
The Sharper Image demineralization cartridge will help reduce the potential
for white dust, a deposit of minerals left behind from using hard water in your
humidifier. The cartridge should be replaced every 30 – 40 fillings. The cartridge
may need to be replaced more often if you are using very hard water. Replace
the cartridge when you notice an increase in white dust build-up. If white dust
still forms around the humidifier after a new cartridge has been installed, consider
using distilled water. To purchase new demineralization cartridges, model
# EV-HDDC4-6CTM, go back to the retailer (where you purchased your
humidifier), or visit www.sharperimageparts.com. If you live in an area with
hard water, or use a water softener, we recommend using distilled
water for better results from your humidifier. Never use water
softening additives in your humidifier.
Installation Instructions:
1. Remove demineralization cartridge from packaging and let it soak in water for 10
minutes.
2. Remove the tank from humidifier base and turn it over.
3. Unscrew the tank cap by turning the cap counter-clockwise.
4. fill the tank with water as shown in the How To Fill Section.
5. Place 1 blue demineralization cartridge into the tank.
6. Replace the tank cap by turning clockwise.
7. Place the tank back on the base, making sure the tank is firmly seated.
1 1