Installing The Main Battery - Motorola MC75A Integrator Manual

1 - 2 MC75A Enterprise Digital Assistant Integrator Guide
Charge the main battery before or after it is installed. Use one of the spare battery chargers to charge the
battery (out of the MC75A), or one of the cradles to charge the battery installed in the MC75A.

Installing the Main Battery

NOTE The MC75A ships with either a 1950 mAh or a 3600 mAh battery. An optional 4800 mAh battery is
available.
To install the main battery.
Insert the battery, top first, into the battery compartment in the back of the MC75A.
1.
NOTE Position the battery correctly, with the battery charging contacts on top of the charging contacts in the
battery compartment.
Press the battery down into the battery compartment until the battery release latch snaps into place.
2.
Battery
Inserting the Battery
Figure 1-1
With the battery cover latches open, insert the cover, bottom first, then press down on the top of the cover.
3.
Close the battery cover latches on either side of the battery cover.
4.
Insert the handstrap through the handstrap slot, then tighten and press down to secure.
5.
Handstrap
Inserting the Handstrap
Figure 1-2
The MC75A powers up after inserting the battery and replacing the battery cover.
Release Latch
Handstrap Slot
Battery Cover Latch
Battery Cover