Adjusting Cutting Height; Towing - Scag Power Equipment STC48V-19KAI Operator's Manual

Section 4
Figure 4-4 Deck Release Lever
HEIGHT ADJUSTMENT
PEDAL
Figure 4-5 Adjusting Cutting Height
4.14 TOWING (optional hitch accessory)
1. Never allow children or others in or on towed
equipment.
2. Tow only with a machine that has a hitch designed
for towing. Do not attach towed equipment except at
the hitch point.
3. Follow manufacturer's recommendations for weight
limit for towed equipment. 250lbs. maximum towing
weight.
4. Never tow on slopes. The weight of the towed
equipment may cause loss of traction and loss of
control.
DECK RELEASE LEVER
STC 2006 DRL
LANYARD
PIN
STC 2006 ACH
19
5. Travel slowly and allow extra distance to stop.
6. Zero turning with a trailer attached, could cause
damage to the trailer or mower.
4.15 Adjusting the Steering Levers
1. Position the seat to the desired location.
2. While in the operator's position with out the engine
running, move both steering levers forward and
reverse to check for full function control and
comfort.
3. If adjustment of the steering levers is needed, use the
following instructions to adjust.
A. Loosen the tension knob on the lever assembly.
B. Rotate the steering lever forward or backward to
achieve the optimum operating position.
C. Tighten the tension knob and repeat on the
opposite side.
D. While in the operators position, bring the steering
levers out of the neutral lock position and check
to make sure both levers are even before
operating.
Figure 4-6 Adjusting Steering Levers
4. The control handle can also be adjusted in two
different positions. If necessary, remove the two
bolts securing the control handle to the control lever.
Install the handle in the desired position.
ROTATE
LEVER
TENSION
KNOB