Touch Pad - Toshiba Satellite Pro U300 Maintenance Manual

Replacement Procedures
4.13

Touch pad

Removing the touch pad
The following describes the procedure for removing the touch pad (See Figure 4-22).
1. Peel off the glass tape and disconnect the touch pad flat cable from the connector on
the touch pad and peel the al foil.
2. Remove the following screws securing the touch pad plate.
• M2.5×3.0B
3. Turning up the insulator, remove the touch pad plate.
4. Peel off and remove the touch pad from the cover assembly.
Touch pad
M2.5x3.0B
Touch pad board
M2.5x3.0B
Installing the touch pad
The following describes the procedure for installing the touch pad (See Figure 4-22).
1. Peel off the separator covering on the sensor portion of a new touch pad.
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08) 44
SUPER THIN HEAD screw
Touch pad plate
Figure 4-22 Removing the touch pad
x7
M2.5x3.0B
Touch pad flat cable