Toshiba Satellite Pro U300 Maintenance Manual page 216

Replacement Procedures
Installing the cover assembly
The following describes the procedure for installing the cover assembly (See Figure 4-19 to
4-21).
1. Install the cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.5×6.0B
• M2.5×6.0B
• M2.5x4.0 B
4. Free the cable from cable-drain when through the antenna cable to PCB hole.
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)43
FLAT BIND screw Front
FLAT BIND screw Back
FLAT BIND screw
x3
x18
x1