Vlan; Add A New Vlan; Remove A Vlan - D-Link DFL-1100 Manual

Hide thumbs Also See for DFL-1100:

Table of Contents

VLAN

Click on System in the menu bar, and then click VLAN below it, this will give a list of all

configured VLANs, it will look something like this:

Follow these steps to add a new route.

Step 1. Go to System and VLAN.

Step 2. Click on Add new in the bottom of the routing table.

Step 3. Choose the interface that the VLAN should be on from the dropdown menu.

Step 4. Specify the 801.2Q VLAN ID.

Step 5. Fill in the IP address of the VLAN interface. This is the address that will be used to

ping the firewall, remotely control it and use as gateway for hosts on that VLAN.

Step 6. Choose the correct Subnet mask of this interface from the drop down menu.

Click the Apply button below to apply the setting or click Cancel to discard changes.

Follow these steps to add a remove a route.

Step 1. Go to System and VLAN.

Step 2. Take Edit after the VLAN you would like to remove.

Step 3. Check the checkbox named Delete this VLAN.

Click the Apply button below to apply the setting or click Cancel to discard changes.

Table of Contents