Removing The Power Supply And Library Controller (Msl4048 Only) - HP StoreEver MSL2024 User And Service Manual
Hide thumbs
Also See for StoreEver MSL2024:
- Quickspecs (26 pages) ,
- Quickspecs (25 pages) ,
- Quickspecs (30 pages)
Table of Contents
Advertisement
1.
Loosen the blue captive thumbscrews on the drive (see
Figure 110 Captive screws on the tape drive
2.
Pull straight back on the tape drive handle to remove the tape drive from the library (see
Figure 111 (page
Figure 111 Removing a tape drive
3.
Repeat Steps 1 and 2 for all other tape drives.
Removing the power supply and library controller (MSL4048 only)
On the MSL4048, the power supply and library controller are moved to the new chassis.
To remove the power supply:
1.
Loosen the three captive thumbscrews on the power supply.
2.
Grasp a thumbscrew stem on each side of the power supply. Support the bottom while pulling
the power supply out of the library, as shown in
Figure 112 Removing the power supply
199)).
Figure 110 (page
Figure 112 (page
199).
Removing and replacing the base chassis 199
199)).
Advertisement
Table of Contents
