HP StoreEver MSL2024 User And Service Manual page 177

Table 40 Warning event codes (continued)
Event code Description
58 Parity error
59 Error log overflow
5A Unable to downgrade firmware while encryption
enabled.
5B Invalid cartridge. LTO3 media is not supported
with encryption enabled.
5C IPv6 will not be supported after downgrading
firmware.
5D Wrong drive firmware — invalid drive firmware
type.
5E Illegal drive position of FH drive.
5F No firmware downgrade possible.
60 Cleaning tape installed.
61 Cleaning failure. Cleaning process could not be
performed.
62 Cleaning tape expired.
63 Invalid cartridge. Drive has rejected the cartridge
as invalid.
64 Invalid cleaning cartridge. Drive has rejected the
cartridge as invalid.
Details and Solution
NOTE: The PIN is required every time a token
is installed in the USB port and every time the
library is powered on.
Retry the operation.
If the problem continues, contact Hewlett
Packard Enterprise customer support.
Disable encryption before downgrading firmware.
Verify that the tape cartridge is supported.
Update the tape drive firmware to the latest
version to use LTO3 media.
Change the network settings to IPv4 before
downgrading firmware.
Drive firmware is specific to the drive model and
interface. Select the drive firmware specific to this
drive. If the firmware file could have been
renamed, obtain a new copy of the firmware file
In an MSL4048, a full-height tape drive cannot
be installed in the middle two drive bays; it must
be installed in either the upper two drive bays or
lower two drive bays. Reinstall the tape drive in
a supported drive bay.
The device firmware cannot be downgraded in
cases that would compromise encrypted data,
critical component support, or license terms.
Check the configuration settings. If the device
has been using the Encryption Kit, you might need
to disable encryption before downgrading
firmware. If the Library Extender is installed, you
might need to uninstall the Library Extender
before downgrading firmware.
Complete the cleaning process and retry the
operation.
Check cleaning tape and exchange if
necessary.
Retry the operation.
Exchange the cleaning tape.
Verify that the cartridge generation and
technology are supported by the device. See
"Tape cartridges" (page
Retry the operation.
If problems persist, exchange the data
cartridge.
43).
Warning events 177