Trouble Shooting With No Error Code - Fujitsu AS* A09LEC Service Instruction

2-3 TROUBLE SHOOTING WITH NO ERROR CODE

Trouble shooting 22
Indoor Unit - No Power
Check Point 1 : Check installation condition
Isn't the breaker down?
Check loose or removed connection cable.
>> If abnormal condition is found, correct it by referring to
Installation Manual or Data & Technical Manual.
OK
Check Point 2 : Check external cause at indoor unit and outdoor unit(Voltage drop or noise)
Instant drop ----- Check if there is a large load electric apparatus in the same circuit.
Momentary power failure ----- Check if there is a defective contact or leak current in
Noise ----- Check if there is any equipment causing harmonic wave near electric line.
(Neon bulb or electric equipment that may cause harmonic wave)
Check the complete insulation of grounding.
OK OK
Check Point 3 : Check electrical components
Check the voltage of power supply.
>> Check if AC198(AC220V-10%) - 264V(AC240V+10%) appears at indoor unit
Terminal L - N (Power supply).
OK
Check Fuse on Controller PCB (F1).
>> If Fuse is open, check loose terminal, and replace Fuse.
Check Varistor on Controller PCB (VA1).
>> If Varistor is defective, there is a possibility of an abnormal power supply.
Check the correct power voltage.
Forecast of Cause:
1. Power supply failure
3. Electrical components defective
the power supply circuit.
2. External cause
02-24
NO