Trouble Shooting With Error Code - Fujitsu AS* A09LEC Service Instruction

2-2 TROUBLE SHOOTING WITH ERROR CODE

Trouble shooting 1
OUTDOOR UNIT Error Method:
Serial Error
(Serial Reverse Transfer Error)
Detective Actuators:
Outdoor unit Main PCB
Outdoor unit Fan motor
Forecast of Cause:
1. Connection failure
Check Point 1-1 : Reset the power and operate
Does error indication reappear?
YES YES
Check Point 2 : Check connection
Check any loose or removed connection line of
between indoor unit and outdoor unit.
>> If there is an abnormal condition, correct it by
referring to Installation Manual or Data &
Technical Manual.
Check connection condition in control unit.
(If there is loose connector, open cable or mis-wiring)
OK
Check Point 3 : Check the voltage of power supply
Check the voltage of power supply
>> Check if AC198(AC220V-10%) - 264V(AC240V+10%) appears
at outdoor unit terminal L - N.
OK
Check Point 4 : Check serial signal (Reverse transfer signal)
Check serial signal (Reverse transfer signal)
>> Check if indicated value swings between AC70V and AC130V at outdoor unit terminal N - 3.
>> If it is abnormal, check Outdoor unit fan motor. (PARTS INFORMATION 5)
>> If Outdoor unit fan motor is abnormal, replace Outdoor unit fan motor and Main PCB.
>> If Outdoor unit fan motor is normal, replace Main PCB.
BLACK
L
WHITE N
RED 3
Indicate or Display:
Refer to error code table.
Detective details:
When the indoor unit cannot properly receive the serial signal from
outdoor unit for 10 seconds or more.
2. External cause 3. Main PCB failure
NO
+
-
4. Outdoor unit Fan motor failure
Check Point 1-2 : Check external cause such as noise
Check if the ground connection is proper.
Check if there is any equipment that causes harmonic wave
near the power cable (Neon light bulb or any electronic
equipment which causes harmonic wave).
02-03