For Stranded Wiring; Wiring Samples - Panasonic S-12MY2U6 Installation Instructions Manual

Loose wiring may cause the terminal to overheat or result in unit malfunction.
A fire hazard may also occur.
CAUTION
Therefore, ensure that all wiring is tightly connected.
When connecting each power wire to the terminal, follow the instructions on "How to connect wiring to the terminal" and fasten the wire
securely with the fixing screw of the terminal board.
How to connect wiring to the terminal

■ For stranded wiring

(1) Cut the wire end with cutting pliers, then strip the insulation
to expose the stranded wiring approx. 3/8 inch (10 mm) and
tightly twist the wire ends. (Fig. 4-6)
(2) Using a Phillips head screwdriver, remove the terminal
screw(s) on the terminal board.
(3) Using a ring connector fastener or pliers, securely clamp
each stripped wire end with a ring pressure terminal.
(4) Place the ring pressure terminal, and replace and tighten the
removed terminal screw using a screwdriver. (Fig. 4-7)

■ Wiring samples

Y2 type
Functional ground screw
(Louver Motor)
Wire from indoor unit PCB
(white, 5P)
Functional ground screw
(Schedule Timer)
Protective ground screw
(External Solenoid Valve
Kit for 3WAY)
Use this screw when
connecting the shield for the
remote control wiring to ground
Band
Power supply
cord
Stranded wire
Special
Screw
washer
Ring pressure
terminal
Terminal board
Wire
Locknut
Remote control wiring
Conduit
12
Ring
pressure
terminal
Wire
Optional subpart ACC-3WAY-AAB
(part of indoor installation CZ-P56HR1U)
Connect both
connectors
Inter-unit
control wiring
Fig. 4-6
Screw and
Special washer
Ring
pressure
terminal
Fig. 4-7
Band