Display - Toshiba e-STUDIO 200L Service Manual

5.2.1

Display

No. Message
1 -
2 Saving energy - press
START button
3 Wait Warming Up
4 Wait Warming Up
Auto Start
5 WAIT
6 Wait adding toner
7 Performing Auto Calibra-
tion
8 READY
9 READY
Press START button to
copy
10 READY
(WARMING UP)
11 READY
(PRINTING)
12 READY
(ADDING TONER)
13 READY
(INNER TRAY FULL)
14 READY
(CHECK STAPLER)
15 READY
(CHECK STAPLER)
16 READY (ADD PAPER)
Press JOB STATUS button
17 READY
(FINISHER FULL)
18 READY
(HOLE PUNCH DUST BIN
IS FULL)
19 READY
(SADDLE STITCH TRAY
FULL)
20 READY
(CHANGE DRAWER TO
CORRECT PAPER SIZE)
21 Ready for bypass feeding
22 COPYING
23 Auto Start
June 2004 © TOSHIBA TEC
State of equipment
Power is OFF (at Sleep Mode)
At Energy Saving Mode
Scanner warming up
• Displayed until the equipment
becomes ready to start scanning
Scanner warming up
• Displayed when Auto Start is set
Displayed when performing the con-
trolling function to keep the equip-
ment at the best condition
Supplying toner
• Equipment becomes the toner
supply state
Displayed at image quality control
Ready for copying
• Waiting for the operation
Copying job interrupted
Scanner warming up
Printing out the data
• Scanning is enabled
Supplying toner
• Scanning is enabled
Inner tray in the equipment is full
• Scanning is enabled
No staples in finisher
• Scanning is enabled
Stapling jam occurred in finisher
No paper in drawer
• Scanning is enabled
Finisher is full of paper
• Scanning is enabled
Punching dust box is full
• Scanning is enabled
Saddle stitcher tray is full of paper
• Scanning is enabled
Incorrect paper size setting
Paper is set on the bypass tray
At the copying state
Auto Start is set during printing
5 - 3
Note
Press [START] button or [FUNC-
TION] button to clear
Press [START] button to clear
Auto Start can be set
Press [STOP] button to clear the
Auto Start
Recovers when the toner supply has
finished
Recovers when the image quality
control has finished
Press [START] button to resume
copying or press [MEMORY CLEAR]
button to delete the job
- When the bridge unit is installed
- Resumes printing by removing
papers from the tray
Cleared by supplying the staples
Cleared by supplying papers
Resumes printing by removing paper
from the finisher
Resumes printing by removing
punching dust from the dust box
Cleared by pressing [RESET] button
or [STOP] button
e-STUDIO200L/202L/230/232/280/282 CONTROL PANEL
5