Yamaha YZF-R1B 2012 Service Manual page 109

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Rear frame
2. Battery box 1
3. License plate light lead
4. Left turn signal light lead
5. Right turn signal light lead
6. Battery box 2
7. Tail/brake light lead
8. Lean angle sensor lead
9. Lower tail cover bracket
10.Main harness
11.Starter relay
12.Starter motor lead
13.Battery cover
14.Front frame
15.Battery negative lead
16.Plastic band
17.Battery positive lead
18.Lead cover
19.Fuse box
20.Tool band
21.Battery seat
22.Battery
23.Tool
A. Pass the main fuse lead through the guide
of the battery box 1.
B. Insert the main fuse until it is completely
over the tab projection of the battery box 2.
C. Put the anti-theft alarm lead coupler in
front of the dividing rib of the battery box 2
for Australia.
D. Route the tail/brake light lead through the
left of the battery box 2 boss.
E. After passing the tail/brake light lead,
license plate light lead, right turn signal
light lead and left turn signal light lead
through the guide of the battery box 2,
route them between the ribs.
F. When installing the seal, align it to the
push pin trace mark of the rear frame (both
left & right).
G. Slip the seal in between the rear frame and
the battery cover (both left & right).
H. Align the positioning tape of the battery
negative lead to the clamp.
I. Face the excess end of the plastic band to
inside and the end should not be above the
tool reception bearing surface of the bat-
tery box 1.
J. Align the positioning tape of the starter
motor lead to the clamp.
K. Up/down position of the battery negative
lead and starter motor lead is shown in the
illustration.
L. Install the battery positive lead (red) on top.
M. Put the lead cover on after connecting the
starter motor lead to the starter relay.
email: info@motomatrix.co.uk
N. Insert the fuse box until back of the tab of
the battery box 2.
O. Black
P. Green
Q. Brown
R. Blue
S. Installing direction of the tool is insignifi-
cant.
T. Bend the battery seat inward.
U. Install the main harness with its tab fitted
inside of the battery box 1.
2-68
CABLE ROUTING