Precor C842 Service Manual page 52

Diagram 7.12 - Internal Hand Held Heart Rate Cable
Blue Tape
27. Feed the wire ends out of the handlebars so that the black wire comes out of the top of the
handlebars and the red wire comes out of the bottom of the handlebar.
28. Connect the black wires to the hand held heart rate top contact plates and the red wires to
the bottom contact plates. Fasten the hand held heart rate contact plates with the screws
removed in step 25.
29. Connect the existing or replacement external hand held heart rate cable to the internal hand
held heart rate cable. Feed the cable connectors into seat.
30. Replace the cover plate removed in step 22. Before replace the cover plate mounting
screws, be sure that the cable is centered on the cover plate so that the cover plate
mounting screws will not damage the external hand held heart rate cable.
31. With the seat cable extended to the rear of the seat, slide the seat onto the seat rail to its
most forward position.
32. Extract the hand held heart rate cable from the seat rail and connect it to the hand held heart
rate seat cable. The cables should again look as they did in Diagram 7.9.
33. Slide the cable connectors back into the seat rail and replace the plate removed in step 18.
Stick the plate to the double sided tape on the cable and fasten the plate to the seat rail with
the screws previously removed.
34. Carefully feed all of the excess cable back under the seat.
35. Replace both seat stops. Replace the end cap.
36. If necessary, adjust the seat wheels per Procedure 5.3.
C842, C842i, C846, C846i Upright and Recumbent Cycle
Black Tape
Page 52