Sony HTC-NX300 Service Manual page 11

TRAY (SUB)
1 Rotating the pulley (LD), shift the slider (selection) in the arrow A direction.
2 Rotating the pulley (mode) in the arrow direction, adjust the tray (sub) to be removed.
3 Rotating the pulley (LD), shift the slider (selection) in the arrow B direction.
4 Rotating the pulley (mode) in the arrow direction, remove the tray (sub) to be removed.
CHASSIS (MOLD B) SECTION, STOCKER SECTION AND
SLIDER (SELECTION)
Note: In mounting the parts, refer to page 12 and 13.
4 two step
screws
pulley (LD)
stocker
section
tray (sub)
6 two screws
5 stocker
section
pulley (LD)
4 two step screws
A
(PTPWH M2.6)
7 slider (selection)
8 washer
9 compression
spring
3 gear (eject)
slider (selection)
B
pulley (mode)
1 three screws
(BVTP M2.6)
2 chassis (mold B) section
Note: Rotating the pulley (LD),
shift the slider (selection)
to the left.
11