Printer Skew Specifications - Lexmark T650 Service Manual

4062-XXX

Printer skew specifications

Abnormal skew printer correction
STEP ONE: The repair operator should ev aluate the left edge of the paper to determine if the aligner is
properly set. If the left vertical line is with the defined limit, parallel to the edge of the paper, the aligner is
correct and properly set. If the left edge vertical line is not within the defined limit spec the repair operator can
adjust the aligner at the repair station.
STEP TWO: The repair operator should evaluate the horizontal line at the top edge of the page for potential
LSU induced skew. If the horizontal line does not fall within the defined limit or spec, then it is considered
skewed and the printhead must be adjusted. Go to
registration adjustment" on page
3-110
Service Manual
4-2.
Lexmark C544
Quick Test
Printer Information Margin Settings
Page Count xx Top Margin = x
PSAC xx
Bottom Margin = x
Installed Memory xxx MB Left Margin = x
Processor Speed xxxMHz Right Margin = x
Serial Number xxxxxxx Skew = x
CalStat xxxx Cyan Top Margin = x
CalSet x.xx x.xx x.xx Cyan Left Margin = xx
x.xx x.xx Cyan Right Margin = x
Engine ID xx
Cyan Skew = x
FSpeed xxx Cyan Bow = x
Printer Rev isi on Lev els Yellow Top Margin = x
Yellow Left Margin = x
Loader xx.xx.xxxx-x
Kernel xxx.xx.xxxx-x Yellow Right Margin = x
Yellow Skew = x
Base xx.xx.xxxx-x
Network xxx.xx.xxxxx-x Yellow Bow = x
Magenta Top Margin = x
Network Drvr xx.xx.xxxx-x
Engine xx.xx.xxxx-x Magenta Left Margin = x
Font x.xxxxx-xx.x Magenta Right Margin = x
Magent Skew = x
magenta Bow = x
Dup Top Margin = x
Paper Source = Tray 1
Formatted Size = xxxxxx
Straight
Printhead Skew + Paper Feed Skew
"Polygon and Oscillating printhead mechanical
Skewed
Previous
Next
Go Back