Repeat / Series / 1 Shot Recording - Honeywell hr960 Manual

REPEAT RECORDING / SERIES RECORDING
When the "REPEAT REC" of the "VCR SET UP" menu is set to ON (the repeat indicator is
illuminated), the tape will automatically be rewound to the start when the tape end is
reached. Then recording will start again.
Continue the repeated video recording to the tape end after recording the alarm, when the
alarm signal is input when the video recording is repeated, and stand by at stop after
rewinding.
* If it happens more than one alarm recording, the repeat recording will not be operated.
1. Set SERIES REC to ON on VCR SET UP screen.
2. Connect SERIES OUT terminal in rear panel to SERIES IN of another set.
* Refer to page 10 (connecting another units in series)
This defines the interval time that one picture is recorded, 1 sec., 3 sec., 5 sec., 30 sec., 60
sec. or OFF.
1. If you select the '000H' option in normal recording, the VCR will activate the '1SHOT REC'
mode function. This will record a single shot picture after each defined time interval which
is programmed in the '1SHOT REC' menu.
2. If you select '1SHOT REC' OFF, the unit will record one picture each time the external
1SHOT REC input is activated.
3. Press the MOVE button to choose the 1SHOT REC option.
4. Press the SELECT button to select the desired time of recording, 1 sec., 3 sec., 5 sec., 15
sec., 30 sec., 60 sec. or OFF.
REPEAT RECORDING
SERIES RECORDING
1 - SHOT RECORDING
N O T E
* SERIES recording may have a short
pause ( ≈ 5 seconds) when going from
recorder A to recorder B.
* When set in above configuration and
the first VCR reaches the end of the
tape, the second VCR automatically
begins recording.
* series recording will not function
during timer recording.
English-19