Rear Panel - Honeywell hr960 Manual

1. ALARM IN terminal
2. ALARM OUT terminal
3. SERIES IN terminal
4. SERIES OUT terminal
5. TAPE END terminal
6. TRIGGER OUT terminal
7. GND(GROUND) terminal
English-8
Input terminal to alarm recording. The
alarm sensor is connected here.
Output terminal to indicate alarm
recording to an external alarm.
Input terminal to start/stop recording.
Also, use this terminal for series
recording or synchronous recording.
Output terminal to use series recording or
synchronous recording.
Output terminal to indicate when tape
has finished recording.
Output terminal to control an external
camera switcher
When a lead connected other terminals
requires a ground, connect the ground
lead here.

REAR PANEL

8. KEY IN terminal
Wired remocon(option) jack in terminal.
9. 1- SHOT REC IN terminal
Input terminal to use 1-shot recording.
10. AUDIO IN connector
Audio input connector (RCA pin)
11. AUDIO OUT connector
Audio output connector(RCA pin)
12. VIDEO IN connector
Input connector for video signal (BNC
connector)
13. VIDEO OUT connector
Output connector for video signal (BNC
connector)
14. MIC IN terminal
Input connector for MIC (Mono)