Audio Settings - Kenwood kdc-bt420u Instruction Manual

AUDIO SETTINGS

While listening to any source...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [AUDIO CONTROL], then press the knob.
3
Turn the volume knob to make a selection (see the following table), then press
the knob.
4 Repeat step 3 until the desired item is selected or activated.
5 Press and hold to exit.
(or using RC-406)
1 Press AUD to enter [AUDIO CONTROL].
Press J / K to make a selection, then press
2
To return to the previous setting item, press
SUB-W LEVEL –15 to +15 (0)
BASS LEVEL –8 to +8 (+6)
MID LEVEL –8 to +8 (+5)
TRE LEVEL –8 to +8 (0)
EQ PRO
BASS ADJUST BASS CTR FRQ
BASS LEVEL
BASS Q FACTOR
BASS EXTEND
MID ADJUST MID CTR FRQ
MID LEVEL
MID Q FACTOR
TRE ADJUST TRE CTR FRQ
TRE LEVEL
.
.
Adjusts the subwoofer output level.
Adjusts the level to memorize for each source. (Before making an
adjustment, select the source you want to adjust.)
60HZ/ 80HZ/ 100HZ/ 200HZ: Selects the center frequency.
–8 to +8 (+6): Adjusts the level.
1.00/ 1.25/ 1.50/ 2.00: Adjusts the quality factor.
ON: Turns on the extended bass. ; OFF: Cancels.
0.5KHZ/ 1.0KHZ/ 1.5KHZ/ 2.5KHZ: Selects the center frequency.
–8 to +8 (+5): Adjusts the level.
0.75/ 1.00/ 1.25: Adjusts the quality factor.
10.0KHZ/ 12.5KHZ/ 15.0KHZ/ 17.5KHZ: Selects the center frequency.
–8 to +8 (0): Adjusts the level.
PRESET EQ
BASS BOOST
LOUDNESS
SUBWOOFER SET
Default: XX LPF SUBWOOFER THROUGH: All signals are sent to the subwoofer. ;
SUB-W PHASE
HPF
DRIVE EQ/ TOP40/ POWERFUL/ ROCK/ POPS/
EASY/ JAZZ/ NATURAL/ USER: Selects a preset
equalizer suitable to the music genre. (Select [USER]
to use the customized settings.)
[DRIVE EQ] is a preset equalizer that reduces noise
outside the car or running noise of the tyres.
LEVEL1/ LEVEL2/ LEVEL3: Selects your preferred
bass boost level. ; OFF: Cancels.
LEVEL1/ LEVEL2: Selects your preferred low and high
frequencies boost to produce a well-balanced sound
at a low volume level. ; OFF: Cancels.
ON: Turns on the subwoofer output. ; OFF: Cancels.
85HZ/ 120HZ/ 160HZ: Audio signals with
frequencies lower than 85 Hz/ 120 Hz/ 160 Hz are sent
to the subwoofer.
REVERSE (180°)/ NORMAL (0°): Selects the phase of
the subwoofer output to be in line with the speaker
output for optimum performance. (Selectable only
if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
THROUGH: All signals are sent to the speakers. ;
100HZ/ 120HZ/ 150HZ: Audio signals with
frequencies higher than 100 Hz/ 120 Hz/ 150 Hz are
sent to the speakers.
ENGLISH
17