Table of Contents
Advertisement
12. Terminate the Offline Maintenance utility when the NVRAM information has been loaded from
the floppy disk.
If the System is Unable to Make Backup Copies of NVRAM
Information
13. Set the NVRAM information on the new mother board by taking the following steps.
14. Set the EXPRESSBUILDER CD-ROM in the CD-ROM drive, and activate the
EXPRESSBUILDER.
15. When the EXPRESSBUILDER becomes active, activate the Offline Maintenance utility by
selecting "Tool" from the menu → "Offline Maintenance Utility" → "Manage System
Information."
16. When the Offline Maintenance utility becomes active, select "Menu for Maintenance Persons"
from the menu.
(Screen image)
17. Do not care about a notice displayed, and press the Enter key. The system asks you to enter the
password. Enter the password as shown below.
Password >CENVRAM
18. Select "Update Product/Cabinet Information" when the following screen appears after you enter
the password:
Installing and Removing Components
Offline Maintenance Utility
Offline Maintenance Utility
Manage System Information
Execute the Offline Maintenance Utility
Set Remote Maintenance Information
Return to the Custom Setup Menu
Manage System Information
Save
Menu for Maintenance Persons
Exit
Menu for Maintenance Persons
Restore (at replacement of the mother board)
Update Product/Cabinet Information
Return to the Previous Menu
⇓
47
Advertisement
Table of Contents
