Removing The Processor Board Air Baffle - NEC Express 5800/140Rb-4 Service Manual

Removing the Processor Board Air Baffle

To remove the processor board air baffle:
1. Remove the screw holding the dual power receptacle (located at the top left rear of the chassis)
and pull it clear of the chassis as far as the attached cords will allow (Figure 11, A and B).
2. At the end of the air baffle closest to the rear of the chassis, press the two tabs toward each other
(Figure 11, D) and raise the end, rotating the baffle about 30°.
3. Disengage the air baffle at the front of the electronics bay and remove the baffle from the
chassis.
Installing and Removing Components
A Power receptacle screw
B Dual power receptacle
Figure 11. Removing the Processor Board Air Baffle
C Air baffle
D Release tabs on air baffle
37