HP t610 Series Troubleshooting Manual page 43

Table 4-4 Computer Setup—Security (continued)
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears
after a power cycle or reboot. If the user does not enter the correct power-on password, the unit
will not boot.
Password Options Allows you to enable/disable:
●
(This selection appears
only if a power-on
password or setup
●
password is set.)
●
●
See the Desktop Management Guide for more information.
Device Security Allows you to set Device Available/Device Hidden (default is Device Available) for:
●
●
●
●
●
●
●
USB Security Allows you to set Enabled/Disabled (default is Enabled) for:
●
●
●
Slot Security Allows you to disable any PCI Express slot. Default is enabled.
Network Boot Enables/disables the computer's ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI
expansion card or embedded on the system board.) Default is enabled.
Lock Legacy Resources (determines whether or not Windows Device Manager is allowed to
change resource settings for serial and parallel ports).
Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
the F10 Setup Options without entering setup password). Default is enabled.
Password prompt on F9 & F12 (requires setup password to use these boot functions).
Default is enabled.
Network Server Mode. Default is disabled.
Embedded security device (some models)
System audio
USB 3.0 controller
Network controller
SATA Port 0
SATA Port 1
SATA Port 2
Front USB Ports
◦
USB Port 1
◦
USB Port 2
Rear USB Ports
◦
USB Port 1
◦
USB Port 2
◦
USB3 Port 1
◦
USB3 Port 2
Accessory USB Ports
◦
USB Port 1
Computer Setup (F10) Utilities 37