HP t610 Series Troubleshooting Manual page 26

2. Locate the correct flash memory module socket on the system board.
a. The PATA socket (1) is populated by default.
b. The SATA socket (2) can be populated with an optional SATA flash memory module.
Figure 2-12
3. Align the connector on the flash memory module with the socket on the system board and press
the flash memory module into the socket.
NOTE:
memory module with the retention post on the system board.
Figure 2-13
20 Chapter 2 Hardware changes
Identifying the Flash Memory Module sockets
A flash memory module can be installed in only one way. Line up the hole in the flash
Inserting the flash memory module