Replacing Light Bulbs - Toyota 2001 4Runner Owner's Manual

WWW.MANUALS.WS

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
278
WWW.MANUALS.WS
'01 4Runner_U (L/O 0008)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact
Toyota dealer.
2001 4RUNNER (OM35768U)
Bulb
Light bulbs
No.
Headlights — 60/55
Front fog lights —
Parking and front
—
side marker lights
Front turn signal
—
lights
your
Rear turn signal
—
lights
Stop/tail lights —
Back–up lights —
License plate light —
High mounted
921
stoplight
Interior light —
Personal lights —
Glove box light —
Luggage
—
compartment light
A: HB2 halogen bulbs
B: H3 halogen bulbs
C: Wedge base bulbs (clear)
D: Wedge base bulbs (amber)
E: Double end bulbs
W Type
A
55 B
5 C
21 C
21 D
21/5 C
18 C
5 C
18 C
8 E
8 E
1.4 C
8 E