Horizon Fitness ELITE T7 Assembly Manual page 4

PRE ASSEMBLY
TOOLS REQUIRED:
F T-Wrench
F L-Wrench
UNPACKING
F Phillips Screwdriver (not included)
Place the treadmill carton on a level flat surface. It is recommended that you place
PARTS INCLUDED:
a protective covering on your floor. Take CAUTION when handling and transporting
F 1 Main Frame
this unit. Never open box when it is on its side. Once the banding straps have been
F 2 Console Masts removed, do not lift or transport this unit unless it is fully assembled and in the upright
folded position, with the lock latch secure. Unpack and assemble the unit where it
F 1 Console
will be used. The enclosed treadmill is equipped with high-pressure shocks and may
F 2 Water Bottle Holders
spring open if mishandled. Never grab hold of any portion of the incline frame and
F 2 Handlebars
attempt to lift or move the treadmill.
F 2 Main Frame Covers
F 2 Console Mast Covers
F 1 Polar Chest Strap
®
F 1 Hardware Kit
• DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
F 1 Safety Key
from packaging until specified to do so in the assembly instructions. You may
F 1 Power Cord remove the plastic wrap from console masts.
F 1 Audio Adapter Cable
• FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NEED HELP?
• During each assembly step, ensure that ALL nuts and bolts are in place and
If you have questions or if there partially threaded. It is recommended you complete the full assembly of your
are any missing parts, contact unit before completely tightening any ONE bolt.
Customer Tech Support. Contact
• Several parts have been pre-lubricated to aid in assembly and usage. Please
information is located on the
do not wipe this off. If you have difficulty, a light application of lithium bike
back cover of this manual.
grease is recommended.
6
HZ14_AG_Elite_T7_T9_r1_2.indd 6-7
WARNING
IMPORTANT NOTES
ASSEMBLY STEP 1
1
A
HARDWARE FOR STEP 1
PART TYPE QTY
A HEX SOCKET BOLT 2
A Cut the yellow banding straps and lift the
running deck upward to remove all contents
from underneath the running deck.
B Open hardware for STEP 1.
C Insert 2 BOLTS (A) into MAIN FRAME (1).
7/2/14 3:55 PM
7