Advertisement
OPERATION
1. Unpack the Ultrasonic Jewelry Cleaner, basket and bracelet/
watch holder from the box and plastic wrapping.
2. Connect to electrical power source. DO NOT turn the Ultrasonic
Jewelry Cleaner on unless you have first filled up the tank with
water.
3. To open the Ultrasonic Jewelry Cleaner transparent cover,
press the crescent shaped gray button that is located above the
LED digital display to automatically expose the tank and add
the appropriate amount of water. Fill the solution level to the
MAX fill line as clearly marked on the rear center portion of the
stainless steel tank wall. DO NOT allow the water to evaporate
below this level or fill the tank above this level, as damage may
occur and the warranty will become void.
For tougher stains, dirt and grease add a
SparklePak to the water (Item No. 200706,
sold separately at SharperImage.com).
You may also add a small amount of
dishwashing soap with a degreasing agent.
DO NOT use flammable liquids, ammonia or acid/water mixtures
in the ultrasonic tank as damage may occur and the warranty will
become void. Keep the evaporation-free cover closed when not in
use to reduce solution evaporation.
4. BEFORE CLEANING JEWELRY, READ THE SECTION "What May
& May Not Be Cleaned in an Ultrasonic Jewelry Cleaner"
(page 5). Place the item to be cleaned in the supplied basket
and then submerge it in the tank and close the cover. (As a
3
Advertisement
