Thank you for purchasing the Ultrasonic Eyeglass Cleaner. Please take a moment to read this
guide and store it for future reference.
INTRODUCTION
The Ultrasonic Eyeglass Cleaner removes built-up dirt, grime, make-up and oil to make your
glasses, readers or sunglasses clean as new in just a few minutes, without heat or harsh
chemicals. Just add water and press a button.
DESCRIPTION OF PARTS
A. Body
B. Cleaning Tank
C. Lid
D. Power/Timer Button
E. Power Cord
F. LED Timer Display
G. Basket
H. Watch Shelf
IMPORTANT: Never turn this device on when the tank is empty. Always place items in the basket
before immersing in the tank. Cleaning items without the basket could damage the device.
OPERATING INSTRUCTIONS
1. Open the lid of the device and place glasses into the cleaning basket. Place the basket into
the tank.
2. Fill the tank with tap water. NOTE: Water should cover the glasses but not exceed the MAX
mark. Running without water can damage the unit.
3. Close the lid.
4. Plug the unit into an AC outlet. The LED timer will begin to flash.
5. Press the TIMER button to choose a cleaning session (90/180/280/380/480 seconds).
6. Press the POWER button to start cleaning. When the timer reaches 0, the device will stop
cleaning.
7. You may repeat the process if necessary. However, we recommend waiting at least 5
minutes between cleaning cycles.
8. After cleaning, turn the device OFF and unplug it from the outlet. Remove your cleaned
glasses from the tank.
ULTRASONIC EYEGLASS CLEANER
Item No. 203808
User Guide
- 1 -