Capture Modes - Moultrie GAMESPY M100 Instructions Manual

Slide the UNLOCK switch on the bottom of Camera and use the knob to pull
the slide-out Battery Tray. Install four(4) or eight(8) AA size alkaline or
lithium batteries with polarities as indicated in the Battery Tray. Re-install
the Battery Tray.
Thread the provided Mounting Strap through the Eyelets on the back of the
camera and secure to a tree or pole approximately 36" from the ground as
shown.
Turn Camera on by sliding ON/OFF/AIM switch to
the ON position.
Press the MODE button one time to get to the
Camera Setup Menu. Set Time and Date by pressing
ENTER, using UP/DOWN to adjust selected field,
LEFT/RIGHT to move to the next field and ENTER
when done.
Press MODE button until MENU SELECTION
screen is displayed. Use the UP/DOWN buttons
until the MAIN SCREEN option is highlighted
yellow. Press ENTER.
Your Camera will now automatically take pictures
whenever an animal is detected in range -based on
the default settings below.
Capture Mode
Photo Quality
Photo Delay after each photo is taken
Multi Shot Count
Digital Zoom
Video Resolution
Video Length
Video Audio
Camera Name
Temperature
Info Strip printed on photos
Plot Frequency
Plot Duration
Default Setting
Delete All?
M100 GameSpy Digital Camera
Eyelet
Mounting
Strap
TRAIL CAM (Still)
HIGH
1 MIN
1-SHOT
NO ZOOM
HIGH
5 SEC
ON
MYCAMERA
Fahrenheit
ON
15 SECONDS
3 HOUR
NO
NO
Page 3

CAPTURE MODES

The GameSpy offers four capture modes as described below. The default capture
mode is Trail Cam.
TRAIL CAM MODE
Still photos are taken when an animal is detected. The number of photos taken
when an animal is detected is configurable in Settings. Photos are stored in
the in the DCIM/100_MDGC folder on the SD card.
PLOT CAM MODE
The camera takes photos at a specified interval during the day and combines
them together to create a Plot Video (*.MLT file) which can be viewed on the
supplied Moultrie Plot Stalker software. The camera takes a Plot Video twice
a day; once in the morning and once in the evening. The morning Plot Video
begins 30 min before sunrise. The evening Plot Video ends 30 min after
sunset. See chart below as a reference. The length of each Plot Video is
determined by the Plot Duration setting in the camera menu. The camera will
detect the correct sunrise and sunset times automatically and adjust itself
accordingly. The Plot Videos are stored in :/PLOT folder on the SD card.
IMPORTANT: It will take the camera 24hrs to properly adjust to the correct
sunrise and sunset times. As a default the camera will start the morning Plot
Video at 5:30am and end the evening video at 6:30pm. To reset the sunrise
and sunset times back to the default times, use the Default Settings option in
the menu.
Morning Plot Video
HYBRID CAM MODE
Camera operates in Plot Cam mode during the day and Trail Cam Mode during
the night. Thirty minutes after dusk the camera will enter the Trail Cam mode
and take night photos when the PIR sensor is triggered.
4 VIDEO MODE
Camera records a video when an animal is detected by the motion sensor.
During daylight hours the camera will record a video 5, 15 or 30 seconds in
length. During night the camera will record a video with a maximum length
of 10 seconds. The video length is configurable in SETTINGS.
Page 4
M100 GameSpy Digital Camera
Evening Plot Video