Deck 2 Mechanism Check - Technics RS-DV290EG Service Manual

pressed, the fault items are displayed in sequence.
Table 5-1.
FL display
H01 Cassette deck does not operate correctly.
H02 Unit does not record or the unit goes into
recording mode even when the erasure
prevention tabs have been removed from the
cassette.
H03 Tape does not play even when the tape deck
play button is pressed.
The motor operates when the tape deck play
button is pressed even if cassette is loaded in
the deck.
H06 Cassette deck does not detect CrO2 tape.
H07 Cassette deck does not detect Metal tape.
F01 When the tape play button is pressed, tape
advances only slightly and then stops.
F02 TPS (tape program search) does not work.

5.4. Deck 2 mechanism check

1. Press the Deck 1/deck 2 select button to change the flashing Deck
1 indicator to Deck 2. Refer to
2. Press the Deck 2 cassette holder open button to open the Deck 2
Fig. 5-2.
Symptom
Fig. 5-3.
13
Faulty cassette deck mechanism mode
switch (Deck 1: S951, Deck 2: S971), plunger
and capstan motor. / (Check and replace)
Faulty erasure prevention tabs detect switch
(S974, S975) or short-circuit. (Check and
replace)
Faulty tape detect switch (Deck 1: S952
S972) or short-circuit. (Check and replace)
Faulty CrO2 tape detect switch (Deck 1
Deck 2: S973). / (Check and replace)
Faulty Metal tape detect switch (S976).
and replace)
Reel pulse error (Faulty Hall IC). (Check
replace)
Faulty TPS signal detection or faulty plunger
control. / (Check and replace mechanism
control IC)
Cause