Honda 1995 Civic Owner's Manual page 131

Cooling System
FILLER NECK
Fill up to here
6. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
With manual transmission:
(VX)
3.5 (0.92 US g a l , 0.77 Imp gal)
(Except VX)
3.6 (0.95 US gal, 0.79 Imp gal)
With automatic transmission:
3.5 (0.92 US gal, 0.77 Imp gal)
Maintenance
BLEEDER BOLT
7. Pour coolant into the radiator up
to the base of the filler neck.
8. Loosen the bleeder bolt on top of
the engine. Tighten it again when
coolant comes out in a steady
stream with no bubbles.
9. Refill the radiator to the base of
the filler neck. Put the cap on the
radiator, only tighten it to the first
stop. Start the engine and let it run
until it warms up (the radiator
RESERVE TANK
cooling fan comes on at least
twice).
10.Turn off the engine. Check the
level in the radiator, add coolant if
needed. Install the radiator cap,
tighten it fully.
11. Fill the reserve tank to the MAX
mark. Install the reserve tank cap.