Drum Rollers - GE DCVH480EK Technical Service Manual

3. Remove the disconnected touch sensor wire
harness from the 2 top front wire retainers.
Wire Retainer
4. Remove the 4 Phillips-head screws that attach
the drum support to the front panel, then grasp
and lift the drum support 1/4-inch to disengage
it from the cabinet.
5. Lift the drum support up, pull the bottom out,
then disengage the support from the control
panel support bracket.
Wire Retainer
Tab

Drum Rollers

The front of the stainless steel drum rotates on 2
rollers attached to the inside of the drum support.
Each roller is part of an assembly that consists
of a roller, roller shaft, 2 plastic triangular clips, 2
washers, and a 17-mm hex nut.
To remove the rollers:
1. Remove the drum support. (See
2. Using a small fl at blade screwdriver, pry the
front plastic triangular clip from the groove in
the roller shaft.
3. To remove the roller shaft, remove the 17-mm
hex nut that attaches the roller shaft to the front
of the drum support.
– 28 –
.)
Drum Support