Drain Hose
Use the hose clamp and rubber connection
hose, item
"T" from accessory
parts (see figure 2) to connect the
drain hose to the sink, disposer or air gap.
Hotwaterline
lectric supply cable
Figure
10.
H_re
11.
The rear leveling
leg is adjusted
by turning the
center screw at the front of the dishwasher.
The front
leveling
legs are adjusted
by rotating
the front
leveling
legs. See figure 11, above.
If additional
height is needed:
Shims may be added under the leveler
feet.
Figure
12.
The access hole for the drain hose should be 1.25" (32
mm) diameter.
Airgap
f
Rubber connector
Entry mustbe
abovetrap
Figure 13.
6