Installation Of Rubber Drain Hose Adaptor; Installation Of Mounting Brackets - Bosch 800 Series Installation Instructions Manual

Installation of Rubber Drain Hose Adaptor

For a large port, use the drain hose as it is.
1. For a small port, insert the rubber drain hose adaptor
into the drain hose end.
2. Obtain the Rubber Drain Hose Adaptor (J) spring
clamp from the Dishwasher Installation Kit (do not
substitute).
3. Insert the dishwasher drain hose into the end of the
drain hose (see Figure 13.) Be sure to fully insert
the drain hose.
4. Use the clamp provided to attach the Rubber Drain Hose
Adaptor to the house plumbing as shown in Figure 14.
Figure 13
G
Figure 14

Installation of Mounting Brackets

Before installing the supplied countertop mounting
brackets, decide which method of securing the
dishwasher into its enclosure will be used. Once the
mounting brackets are installed on the dishwasher,
removing them is difficult and will damage the
mounting brackets and the dishwasher.
The dishwasher can be secured into its enclosure in 2 ways:
NOTE: If your dishwasher opening width measures >18"
(458 mm) use the TOP MOUNT mounting methods. If your
dishwasher opening width measures 18" (458 mm) use
the SIDE MOUNT mounting method.
Top Mount is used for countertops made of wood or other
materials that can be easily drilled, or for openings
wider than 18". Orient the mounting brackets as shown
in Figure 15 and position the two small tabs on
the mounting
the dishwasher's front corners. Push the mounting
brackets down firmly to insert the tabs into the slots.
Side Mount is for countertops made of marble,
granite, or other very hard materials that cannot be
easily drilled. Also, it is for for openings that are 18".
Insert a side mount force distributor (M) in each
side as shown in Figure 16.
J
Torx T 20
brackets over the two
Figure 15
Top Mount
C
Figure 16
Side Mount
slots on
M
11
11