Preparing The Location; Hot Water Supply; Drain Hose; Electrical Supply - Bosch SHU 6800 Installation Instructions Manual

Preparing the Location
Openings for electrical, water and drain lines must be
installed in the marked area as shown in Figures 6 and 7
to avoid interference with the dishwasher frame or other
components.
I I \
! I I
23-5/8"- 24"
(600 - 610 rnm)
3-1/2'
,(90 mm)
1-15/16.
Shut-off
valve
/_
(520 ram)
Hot watersupply line _ )_
Figure 7.
Electrical Supply
Figure 6.
Access holes must be rounded and smooth. Holes must
not be larger than I'A" diameter.
Hot Water Supply
• The hot water line to the dishwasher must provide
between 5 - 120 psi (0.3 - 8.27 bars) water
pressure.
• The hot water heater should be set to deliver 140°F
(60°C) water temperature to the dishwasher.
• A 3/8" minimum O.D. copper tubing inlet line is
recommended.
• All solder connections must be made before water
line is connected to the dishwasher's inlet water
valve. Do not solder within 6 inches (152.4 mm) of
the dishwasher's inlet water valve.
After determining where the water supply line will enter
the dishwasher, drill a 1" (25.4 mm) diameter access
hole and run the line to the approximate fill valve loca-
tion, as shown in Figure 7. It is recommended that a
shut-off valve (not supplied) be installed in the hot water
supply line in a readily accessible location.
Drain Hose
The dishwasher comes with a seven (7) foot drain hose.
An access hole must be made to allow the drain hose to
be run to the drain connection location.
ELECTRICAL SHOCK HAZARD
• DISCONNECT ELECTRICAL POWER AT
THE CIRCUIT BREAKER BOX OR FUSE
BOX BEFORE INSTALLING THE
DISHWASHER.
• ELECTRICALLY GROUND
DISHWASHER.
• USE COPPER CONDUCTORS ONLY.
FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
The electrical supply must be 120 volt, 60 Hz, 12
ampere, properly grounded, positioned as shown in
Figure 7, and should be installed by a qualified
electrician. No other appliances or outlets should be on
this circuit.
Cut a I" (25.4 mm) diameter hole in the cabinet for the
electrical wiring to pass through. If this hole is cut in a
wood cabinet, the hole should be sanded until smooth. If
the hole is cut in a metal cabinet, the edge of the hole
must be covered by a grommet. Run flexible, as codes
permit, cable from junction through hole in cabinet.
Cable should extend 30" from back wall.
4