Connecting Electrical Supply; Grounding Instructions; Panel Installation, Shi Models - Bosch SHU 6800 Installation Instructions Manual

Connecting the Electrical Supply
The electrical supply must be 120 volt, 60 Hz, 12
ampere, properly grounded. Connect with copper wire
only.
ELECTRICAL SHOCK HAZARD
• DISCONNECT ELECTRICAL POWER AT
THE CIRCUIT BREAKER BOX OR FUSE
BOX BEFORE INSTALLING THE
DISHWASHER.
• ELECTRICALLY GROUND
DISHWASHER.
• USE COPPER CONDUCTORS ONLY.
FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
Grounding Instructions
This appliance must be connected to a grounded metal
permanent wiring system; or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment grounding terminal or lead
on the dishwasher. The dishwasher must be properly
grounded before operating. Make sure that the
dishwasher is connected to a suitable ground in
compliance with the NATIONAL ELECTRICAL
CODE, in the United States, or the CANADIAN
ELECTRIC CODE C22. l-latest edition, in Canada as
well as any provincial/state or municipal or local codes
that apply.
Black wires
Green or
bare wires
U.L listed
conduit
CONR_ctor
Figure 16.
After completing wiring and testing, be sure that wires
are pressed back into the terminal box and then securely
fasten the terminal box cover/toe panel in place using
screws from accessory package. See Figures 2 and 17.
Figure 17.
Panel Installation, SHI Models
If you have an SHI model, an integrated model, you will
have additional mounting hardware and a folded
template sheet with installation instructions comprised
of pictograms.
In North America the black, white and stainless steel
models of the integrated series (SHI series), have a
control panel that is 5-5/16" (135 ram) tall. The black
and white models come with a standard extension piece,
dimension "A" in figure 18 and table 1, below. The
stainless steel model comes with two extension pieces,
referred to as the standard and long extension piece in
1hble 1: the standard piece is used for drawer heights
up to 6" (152ram); the long extension piece is used for
drawer heights greater than 6" (152ram) but 6-7/16"
(164ram) or less. These stainless steel extension pieces
are not installed in the control panel. Rather the stainless
steel models ship the two extension pieces loose and
must be inserted as shown in pictogram 5 on the
template sheet.
The purpose of the extension piece is to allow the
increase of the control panel height to try to match the
horizontal drawer line of the cabinets. If your drawers
are taller than the "C'" dimension shown on Table 1 it is
recommended that the extension either be slid in as far
as it will go, or removed and the door made to fit
directly below the control panel.