Demonstration Mode; Switching The System On; Switching The System To Standby Mode; Switching The System To Eco Power Standby Mode (< 0.5 Watt) - Philips FW-C155 Owner's Manual

Demonstration mode

The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
In standby mode, press and holdÇon the
system until " WELCOME" is displayed.
The demonstration will begin.
To deactivate the demonstration
Press and holdÇon the system until
"DEMO OFF" is displayed.
The system will switch to standby mode.
Note:
– If you have not deactivated the demonstration,
it will resume five seconds after the system
switches to Eco Power standby or standby mode.

Switching the system on

In standby/demonstration mode
Press STANDBY ON to switch on the last
selected source.
Press CD 1/2/3, TUNER or
TAPE (TAPE 1/2).
Press OPEN/CLOSE.
The system will switch to CD mode.
In Eco Power standby mode
Press ECO POWER to switch on the last
selected source.
Press CD 1/2/3, TUNER or TAPE 1/2 on the
remote control.
Switching the system to standby
mode
In demonstration mode
Press and hold Ç on the system.
In any other source mode (except Eco
Power standby mode)
Press STANDBY ON (or B on the remote
control).
The clock will appear on the display when the
system is in standby mode.
Basic Functions
Switching the system to Eco
Power standby mode (< 0.5 Watt)
Press ECO POWER (or press and hold B on
the remote control).
"ECO PWR" is displayed, then the display
screen will go blank.
The low power ECO POWER LED will be
lighted.

Dim mode

You can select the desired brightness for the
display.
In any source mode (except standby mode),
press DIM MODE repeatedly to select : DIM 1,
DIM 2, DIM 3 or DIM OFF.
is shown, except for DIM OFF mode.
DIM
DIM Brightness
mode
1
normal
2
half
3
half
OFF
normal
Note:
– In standby mode, pressing DIM MODE to select
half or full brightness for clock display.
Spectrum
Analyser
off
on
off
on
13