Setting and canceling the functions
■
To switch between set and canceled, follow the procedure below:
Vehicles with smart key system: Close all the doors and
STEP
1
switch the "ENGINE START STOP" switch to IGNITION ON
mode. (Perform the step 2 within 10 seconds.)
Vehicles without smart key system: Close all the doors and
switch the engine switch to the "ON" position. (Perform step 2
within 10 seconds.)
STEP
2
1-2. Opening, closing and locking the doors and trunk
Shift the shift lever to P or N, and
press and hold the driver's door
lock switch (
approximately 5 seconds and
then release.
The shift lever and switch posi-
tions
desired function to be set are
shown as follows.
Use the same procedure to can-
cel the function.
or
corresponding
to
1
) for
the
41