Cirrus SR22 Pilot's Operating Handbook And Flight Manual page 401

Cirrus Design
SR22 / SR22T
Landing Without Elevator Control
The pitch trim spring cartridge is attached directly to the elevator and
provides a backup should you lose the primary elevator control
system. Set elevator trim for a 80 KIAS approach to landing.
Thereafter, do not change the trim setting until in the landing flare.
During the flare, the nose-down moment resulting from a power
reduction may cause the airplane to hit on the nosewheel. At
touchdown, bring the power lever to idle.
1. Control Yoke................................................... ATTEMPT TO FREE
Clasp both hands around the control yoke and pull straight back
and forth in a strong, steady, and continuous motion.
2. If no elevator control, attempt to use Trim System to control aircraft
pitch:
a. If Trim System inoperative or has no affect on aircraft pitch:
(1) Perform Forced Landing Checklist.
b. If Trim System affects aircraft pitch:
(1) Flaps ................................................................... SET 50%
(2) Trim ............................................................... SET 80 KIAS
(3) Power .......................AS REQUIRED FOR GLIDE ANGLE
P/N 13772-142
Original Issue: 10-14-09
Section 9
Supplements
7 of 14