Motorola APX 1000 Detailed Service Manual page 713

Theory of Operation: Main Board
Antenna
Harmonic
Switch
Filter
DIG_CTRL_ATTH
Diplexer
3.1.2.1 VHF Front-End
From the 15 dB Step Attenuator (U2702), a VHF signal is routed to the first pre-selector filter
followed by a Low Noise Amplifier (LNA) and a second pre-selector filter. Both filters are discrete
designs and are used to band limit the incoming energy and suppress known spurious responses
such as Image and the ½ IF spur. The LNA active device is an NPN transistor (U304) with active bias
provided by transistor pair (Q303).
The output of the second pre-selector filter is applied to the RF port of the Mixer IC (U507) via a
balun transformer (T506). The Mixer IC is driven by a Local Oscillator (LO) signal at the LO port to
down-convert the RF signal to a 109.65 MHz intermediate frequency (IF). The down converted IF
signal is passed through a crystal filter (FL502) which drives the input of the Abacus 3 Analog to
Digital Converter IC (AD9864) (U601).
3.1.2.2 UHF1/UHF2 Front-End
From the 15 dB Step Attenuator (U2602), a UHF signal is routed to the first pre-selector filter
followed by a Low Noise Amplifier (LNA) and a second pre-selector filter. Both filters are discrete and
tunable designs and are used to band limit the incoming energy and suppress known spurious
responses such as Image and the ½ IF spur. The LNA active device is an NPN transistor (U1932)
with active bias provided by transistor pair (Q1922).
The output of the second pre-selector filter is applied to the RF port of the Mixer IC (U507) via a
balun transformer (T506). The Mixer IC is driven by a Local Oscillator (LO) signal at the LO port to
down-convert the RF signal to a 109.65 MHz intermediate frequency (IF). The down converted IF
signal is passed through a crystal filter (FL502) which drives the input of the Abacus 3 Analog to
Digital Converter IC (AD9864) (U601).
3.1.2.3 700/800 MHz Front-End
From the 15 dB Step Attenuator (U2302), a 700 MHz or 800 MHz band signal is routed to an SPST
band select switch (U402) which selects the 700 or the 800 band signal and routes it to the
appropriate first pre-selector filter (FL401). A second band select switch (U404) selects the output of
the appropriate filter and applies it to an LNA followed by a similar pre-selector filter/ band-select
switch circuit. The signal is then routed to a second LNA (U407) whose output is applied to a discrete
image filter. Both preselector filters are Surface Acoustic Wave designs used to band limit the
received energy and suppress known spurious responses such as Image and the ½ IF spur.
800
15 dB Step
Attenuator
SW SW
700
Figure 3-8. Receiver Block Diagram (700/800 MHz )
800
SW SW
700
To GPS
IF Filter
ABACUS III
ΣΔ ADC
Rx LO
2nd
LO
LO
3-9
Dec.
SSI
Filter
18Mhz
CLK
CLK
Abacus III