Panasonic UB-5315 Operating Instructions Manual page 7

Installation • Do not install the unit where it may be exposed to direct sunlight, near heating
equipment, or near air-conditioning vents as this may cause stretching and/or
discoloration of the screen.
• Do not install the unit in strong sunlight or strong lighting. Proper copying may
become impossible.
• Do not install the unit in locations where the temperature may change suddenly as
this may disable the unit's ability to make copies.
Screen Film • Make thick and dark lines inside the copying
area. Note that any writing inside the shaded
area (on right) cannot be copied.
• Do not allow writing to remain on the screen for
an extended period of time as it will become
harder to erase.
• Do not erase with an overly dirty eraser (see
page 29).
• Do not touch the screen, write with markers, or erase while the screen is moving as
this may result in damage to the unit.
Markers, • Use only the included or designated markers, erasers and thermal transfer film.
Erasers and (See page 34.)
Thermal
Use of accessories other than those included or designated (such as oil-based
Transfer Film
markers) may damage the screen or result in hard-to-erase markings.
• Do not store the thermal transfer film in a location subject to extreme changes in
temperature (such as near air conditioning or heating equipment) as this may cause
condensation on the thermal transfer film and result in poor print quality and/or
paper jams.
• The length of one roll of designated thermal transfer film (Replacement film:
UG-6001) is approximately 50 meters (164 ft.). One roll of thermal transfer film can
make approximately 150 sheets of copies.
Note that the total number of copies may differ depending on the operating conditions.
Also note that the length of the thermal transfer film supplied with the unit is shorter
than the replacement film roll and is only approximately 10 meters (32.8 ft.).
• Store markers horizontally as vertical storage may stop the ink from coming out.
Power Cord • The included power cord is for use with this unit only. Do not use it with other
devices.
• When moving the unit, disconnect the power cord from the electrical power socket
and from the printer's power connector and coil it for transportation as stepping on
the power cord or having it catch on something during movement may result in
damage to the cord.
Replacing • Dispose of the used thermal transfer film in a trash receptacle for burnable trash.
the Thermal
• A negative of the copied image will remain on the thermal transfer film. (To protect
Transfer Film
the security of your information, we recommend cutting up the used thermal transfer
film with scissors or shredder before disposing of it.)
USB Cable • Use a shielded USB cable that is certified as logo by USB-IF.
• If you connect the electronic board to a USB hub, it is not guaranteed to work.
• Do not connect two or more Panasonic electronic boards to a computer. It may
cause the computer operation to become unstable.
Precautions
25 mm (1 " )
0 mm
Copying area
(0 " )
25 mm (1 " )
12.5 mm
( 1 / " )
2
7