JVC KD-ADV6270 Instructions Manual page 297

B
Connecting the parking brake wire /
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
Parking brake
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis or the car.
C
Connecting the crimp connector /
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire to this point.
D
Required connections for DVD playback /
or /
Rear side
KV-MR9010
9-INCH WIDESCREEN MONITOR (not supplied)
* 4
To listen to disc playback sound while in Dual Zone operations (see page 23 of INSTRUCTIONS).
*
4
Parking brake switch (inside the car)
DVD
Video cord (not supplied)
Signal Cord (not supplied)
KS-HP2
* 4
Cordless headphones (not supplied)
* 4
23
Parking brake wire (light green)
Contact the metallic part of the crimp to the wires inside.
Digital optical cable (not supplied)
5
Parking brake wire (light green)
To metallic body or chassis of the car
*
3 Not supplied for this unit.
* 3
Pinch the crimp firmly.
DIGITAL OUT
See "About sounds
reproduced through the rear
terminals."
Audio/video control amplifier or the decoder compatible
with the multichannel digital sources